Archive for October, 2009
GU940SCGB Whirlpool Gold Dishwasher won’t drain
Posted by: | CommentsTo: jumptrout51, whirlpooltech, AJ & JWWebster – many thanks guys for the great info! It seemed there had to be a “fuse” somewhere but I had no idea where or what it could be. I followed the link you gave me & ordered the fuse & new wires. When it gets here & I get them in I’ll let yall know how it goes.
Again, many thanks for all of your help – and thanks especially for this website! God Bless yall!
LSW9700PQ1 Whirlpool washer – no high speed spin
Posted by: | CommentsI checked the clutch in my washer after the spinning cycle and it was really hot. I ordered the clutch. I installed it today and the washer spins like a new one. Thank you very much for all the help and assistance.
LSR6332KQ0 Whirlpool Washer Lid Switch
Posted by: | CommentsExactly what I needed, everything went smoothly. Thanks for the web site and all of the information. Ya’ll sure are going to slow down the appliance repairman’s workload. Soon they may all be like the Maytag repairman.Thanks again,
via Lid Switch.
LAT5004AAW Replacing the Maytag Water Pump 202203
Posted by: | CommentsOK, I did it. I turned the machine on it’s side and loosed the water pump from the machine’s base by removing 3 5/16″ screws. After removing the two hoses attached with hose clamps, the pump slipped right out and the new one went in just as easily. I replaced the new belts that I ordered and the machine runs perfectly. And to think I was ready to go buy a new machine.
WCSR4170G1WW GE Top Load Washer Not Spinning
Posted by: | CommentsThe Reset works…….IT LIVES!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Spinning is working fine now, the LED is blinking 1 time per second and faster with the spin on. We ran it through a whole cycle and it works great again. Can’t thank you guys enough, you have saved us a ton of money!! Thank you, Thank you, have a great weekend guys!!
DU927QWDB1 Whirlpool dishwasher runs great, but door leaks like crazy
Posted by: | CommentsThanks for everyone’s help. This is an awesome service and got me looking in the right direction. It was the vent for sure, ran it twice all the way through and not one drop of water! I guess in 17 years of running perfect I should do some maintenance.
via Whirlpool dishwasher runs great, but door leaks like crazy.
wm2277hs help with washer
Posted by: | CommentsHere’s what the manual has to say regarding the LE code:
The connector (3-pin, male, white) in the MOTOR
HARNESS is not connected to the connector
(3-pin, female, white) of STATOR ASSEMBLY.
• The electric contact between the connectors
(3-pin, male, white) in the MOTOR HARNESS
and 4-pin, female, white connector in the MAIN PWB
ASSEMBLY is bad or unstable.
• The MOTOR HARNESS between the STATOR
ASSEMBLY and MAIN PWB ASSEMBLY is cut (open
circuited).
• The hall sensor is out of order/defective
If you have OHmed out the wire harness from the main PCB to the motor, and have checked the stator on the motor for signs of broken or loose wiring, then you can assume the PCB is bad.
via help with washer.
Frigidaire chest freezer
Posted by: | CommentsI would like to thank the people who helped me with my GE SS fridge problem. It turned out to be the compressor. I replaced the compressor and it has been working fine since.
